Rumplestiltskin

Please define 'route'.  Do you mean the flight plan?

Rumplestiltskin

Flaps and trim can be set by going into [Options] and then the menus for [Axis Assignments] and [Key Assignments].
Check to make sure that you have these set.  On my X52, I use the HAT switches on rear-upper of the throttle lever and on the top-left of the stick.  These control trim and flaps.  My flaps are incrementally controlled by the vertical movement (up/down) on the rear of the throttle.  Remember to set your roll (aileron), pitch (elevator) and yaw (rudder) trim tabs too.

In the [key/axis assignments] menus, the default keys can also be left enabled as a personal choice and do not conflict with HOTAS buttons.

Rumplestiltskin

Hi there.
I have not downloaded this particular model yet but, I have encountered similar problems with other aircraft and by other publishes.  I use P3Dv5 and fly with a HOTAS - Saitek X52.

Firstly, try another multi-engine aircraft that you know works reliably just to test your axis controls.
Once you are happy that the controls work, switch aircraft and see if the problem persists.
Some aircraft models have strange configurations that cause them to be bad if set as the default 'start' plane.

I have the default start aircraft as the Lockheed Lightning F35 and the default start airfield is also unchanged - Randolf Airforce Base.  Although slightly tedious to change these, it's not an issue if you vary your start locations and aircraft on a regular basis.

Also, I have found that sometimes, unplugging the USB connector and then reconnecting can cause the game to 'rediscover' the controller.  This however, is usually only required if the computer went to sleep whilst I was away from the desk whilst the flight sim was minimised during my online browsing.

Chocks away!

GeorgeCaffrey

如何设置航路？

Juanav90

Poor plane

UncleHu

看着还真不错，不知道咋样？

国航ZR

AN -225 R.I.P.

asd1300884997

骑猪上天 发表于 2022-10-02 08:43
好像飞不了，节流阀一直保持在慢车位，推不上去，襟翼也收不上

我正常能用

骑猪上天

好像飞不了，节流阀一直保持在慢车位，推不上去，襟翼也收不上